2429557 - 7030B47 GUIDE device for sliding roof movement control cables - R.R .

Removing ( Refitting )  - 7065C30  interior l/h or r/h grab handle (one) - r+r (all)  - 7065C34  l/h or r/h sun blind (one) - r+r (left and right)  - 7040E10  front courtesy light - r+r - 7040H30  front pillar trim - r r (left and right)  - 7040L40  front compartment scuff strip - r r - 7050A20  one-piece rear seat cushion - r r - 7050A10  rear seat - r+r - 7040H50  rear panel - r r - 7040G30  boot light bulb holder - r r - 7040H38  central pillar upper element - r r (left side)  - 7040H42  rear pillar trim - r r (left side)  - 7040L20  tunnel trim - r r - 7040A18  glove compartment on facia - arrange - 7040A30  Left instrument panel lower TRIM - R.R. - 2125A30  lever/knob cover - r + r - 7040A28  TRIM on gearbox control panel - R.R. - 7040H16  roof panel lining - r r - 7030B70  sun-roof control switch - r+r1. Undo the bolts (1a) and (1b) fixing the centre and side mounting brackets.2. Remove the guide sliding the guide racks towards the outside. Refitting ( Removing ) Position the device sliding the racks inside.Tighten the bolts fixing the side brackets and the centre mounting bracket. - 7030B70  sun-roof control switch - r+r - 7040H16  roof panel lining - r r - 7040A28  TRIM on gearbox control panel - R.R. - 7040A30  Left instrument panel lower TRIM - R.R. - 2125A30  lever/knob cover - r + r - 7040A18  glove compartment on facia - arrange - 7040L20  tunnel trim - r r - 7040H42  rear pillar trim - r r (left side)  - 7040H38  central pillar upper element - r r - 7040G30  boot light bulb holder - r r - 7040H50  rear panel - r r - 7050A10  rear seat - r+r - 7050A20  one-piece rear seat cushion - r r - 7040L40  front compartment scuff strip - r r - 7040H30  front pillar trim - r r (left and right)  - 7040E10  front courtesy light - r+r - 7065C34  l/h or r/h sun blind (one) - r+r (left and right)  - 7065C30  interior l/h or r/h grab handle (one) - r+r (all) Connect the battery terminals.After the battery has been disconnected or a fuse has blown, the system must be initialized again, proceeding as follows:Press the switch in the 'roof closed' position;Keep the switch pressed: the roof will close in stages;Keeping the switch pressed, wait for the roof to close fully until the motor is stopped;Release the switch.