2429752 - 1020A24 crank case oil sump - r + r clean seals for sealant application with engine removed

Removing ( Refitting )  - 1004D40  engine - position on stand and removeRotate the engine on the overhauling stand.1. Undo nuts (1a) and bolts (1b) securing the oil sump to the crankcase.2. Using the tool, cut the silicon sealant along the entire perimeter of the oil sump.

	Name	Country
2	Blade	1.870.718.000

3. Remove the engine oil sump. Refitting ( Removing ) Clean any sealant residues from matching surfaces of sump and engine block.1. Apply an unbroken strip of the recommended sealant to the entire perimeter of the crankcase sump as shown in the figure.

Ensure a perfect join between start and end section.

	Type	Component	Name	Qty.
1	Silicon sealant	PISTON SET	LOCTITE 5900	-

2. Refit crankcase sump (2a) and secure by tightening bolts (2b) and nuts (2c) to the specified torque.

When fitting the crankcase sump, avoid major sideways movements which may remove the sealant.

	Fastening	Component	Ø	Value(daNm)
2b	Bolt	OIL SUMP	M6	1

	Fastening	Component	Ø	Value(daNm)
2c	Nut	OIL SUMP	M6	0.5

Wait at least 1 hour after fitting the engine block sump before replenishing it with engine oil.

 - 1004D40  engine - position on stand and remove .