1084B14 ENGINE OIL PUMP - R+R WITH POWER UNIT REMOVED - Lancia - Ypsilon - eLearn

2429760 - 1084B14 engine oil pump - r+r with power unit removed

) - 1004D10 power unit (manual gearbox), removed, remove and re-build - 1004D40 engine - position on stand and remove - 1020A24 crank case oil sump - r + r clean seals for sealant application with engine removed1. Undo the bolts (1a) and the nut (1b) and remove the water pump (1c).

1. Fit the crankshaft gear locking tool as illustrated in the figure.

	Name	Country
1	Counter-torque	1.870.763.000

Work with flywheel retainer 1860846000 fitted.

2. Undo bolts securing crankcase gear and remove.

1. Undo the bolts (1a) and remove the crankcase front cover (1b) with built-in oil pump (1b), complete with crankshaft front oil seal (1c), oil pump (1d) and oil filter (1e).2. Remove the gasket from the crankcase front cover.

Refitting ( Removing

) Position a new oil pump gasket.Fit the crankcase front cover with built-in oil pump complete intake housing and oil filter and secure by tightening bolts to the recomended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	ENGINE OIL PUMP	M6 x 20	1

	Fastening	Component	Ø	Value(daNm)
-	Bolt	ENGINE OIL PUMP	M6 x 32	1

1. Fit a new crankshaft front cover oil seal (1a) using the tool (1b).

	Name	Country
1b	Fitting tool	1.860.990.000

1. Fit the gear on the crankshaft.2. Fit the crankshaft locking tool.

	Name	Country
2	Counter-torque	1.870.763.000

3. Secure the crankshaft gear by tightening the bolt to the specified torque.

	Fastening	Component	Ø	Value(daNm)
3	Bolt	TOOTHED DRIVE PULLEY	M12 x 1.25	2 + 90°

Apply a continuous line of recommended sealant to external edge of water pump.

Ensure a perfect join between start and end section.

	Type	Component	Name	Qty.
-	Silicon sealant	COOLANT PUMP	-	-

Fit the water pump and fix it tightening the nuts and bolts to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	COOLANT PUMP	M6	1

	Fastening	Component	Ø	Value(daNm)
-	Nut	COOLANT PUMP	M6	1

- 1020A24 crank case oil sump - r + r clean seals for sealant application with engine removed - 1004D40 engine - position on stand and remove - 1004D10 power unit (manual gearbox), removed, remove and re-build