1088D24 RIGID PIPE FOR COOLANT INLET TO WATER PUMP - R + R - Lancia - Ypsilon - eLearn

2428977 - 1088D24 rigid pipe for coolant inlet to water pump - r + r

) Position the vehicle on the ramp. Proceed with removal - 1048A10 air cleaner filtering element - replace . Proceed with removal - 1072C44 exhaust manifold heat shield on bulkhead - r+r . 1. Loosen the band and disconnect the coolant outlet pipe from the climate control heater, water pump rigid inlet pipe side.2. Loosen the band and disconnect the lower radiator coolant outlet hose from the radiator, water pump rigid inlet pipe end.

Recover the coolant which comes out in a suitable container.

3. Undo the bolt (3a) and remove the coolant inlet rigid pipe to the water pump (3b).

Refitting ( Removing

) Place the water pump rigid inlet pipe back in its housing and secure it tightening the bolt to the recommended torque.Connect the lower radiator coolant outlet hose to the water pump rigid inlet pipe and tighten the band.Connect the coolant outlet hose from the climate control heater on the side of the rigid inlet pipe to the water pump and do up the band. Proceed with refitting - 1072C44 exhaust manifold heat shield on bulkhead - r+r . Proceed with refitting - 1048A10 air cleaner filtering element - replace . Refill the engine cooling system with coolant - 0010T20 coolant change . Remove the car from the ramps.