5550D10 BRAKE LIGHT SWITCH - R+R - Lancia - Ypsilon - eLearn

2429430 - 5550D10 brake light switch - r+r

) Ensure that the ignition key is in OFF position, then disconnect the battery negative terminal (-).

	Name	Connector
-	Battery	A1B

1. Disconnect the brake light switch electrical connection.

	Name	Connector
1	Brake pedal switch	I30

2. Turn and remove the brake light switch.

Refitting ( Removing

) Press the brake pedal, then refit the brake pedal switch and turn clockwise/anticlockwise until the retainer tooth can be heard clicking into the seat on the bracket.Release the brake pedal and pull back until the brake servo rod is fully released.

This operation must be conducted carefully because if the switch is not correctly retracted it could keep the brake pedal in an advanced position with the risk of residual torque at the wheels which could cause damage to the brake system.

Check there is clearance between the end of the switch and the contact plate on the brake pedal.Connect the brake light switch electrical connection.Connect the negative (-) battery terminal.Check that the brake lights are off with the brake pedal released in the rest position.