2429678 - 7055B36 protective moulding on rear bumper - r r
Removing
(
Refitting
)
1. Position adhesive tape (1a) along the entire perimeter of the
moulding (1b).2. Move the moulding (1b) releasing the retainers (2a).3. Disconnect the electrical connection for the parking sensors.4. Recover the trim.
Refitting
(
Removing
)
Check that the moulding is
undamaged.Connect the electrical connections for
the parking sensors.Place the moulding in position attaching
the retainers.Remove the protective adhesive tape.
Removing
(
Refitting
)
1. Position adhesive tape (1a) along the entire perimeter of the
moulding (1b).2. Move the moulding (1b) releasing the retainers (2a).3. Disconnect the electrical connection for the parking sensors.4. Recover the trim.