1036B14 OVERHEAD CAMSHAFT - R R ON VEHICLE - WITH CYLINDER HEAD REMOVED - Lancia - Ypsilon - eLearn

2429759 - 1036B14 overhead camshaft - r r on vehicle - with cylinder head removed

) 1. Position the cylinder head (1a) in the vice using the supporting tool (1b).

A stud must be removed from the cylinder head to allow the tool (1b) to be fitted.

	Name	Country
1	Support	1.860.470.000

1. Undo the bolt (1a) for the timing driven pulley, using the tools (1b) and (1c) for counter-torque.

	Name	Country
1b	Support for counter-torque	1.860.831.000

	Name	Country
1c	Spanner for camshaft pulley rotation	1.860.831.002

Check that the camshaft end float is within the recommended values using a dial gauge on a magnetic base.

	Measurement		Value
-	End float (mm)		0.10 - 0.20

If the end float is not within the recommended values, replace the worn components when refitting.1. Undo the bolts (1a) and remove the camshaft bearings (1b) lubrication pipe.2. Undo the remaining bolts (2a) and remove the camshaft caps (2b).3. Remove the camshaft.4. Remove the camshaft front oil seal.

Refitting ( Removing

) Fit the camshaft to the cylinder head.1. Fit the camshaft caps (1a) and the camshaft bearing (1b) lubrication pipe and secure it tightening the bolts (1c) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1c	Bolt	CAMSHAFT CAPS	M8 x 1.25	2

	Fastening	Component	Ø	Value(daNm)
1c	Bolt	CAMSHAFT OIL SEAL	M6 x 1	1

2. Fit the camshaft front oil seal (2a) using the tool (2b).

	Name	Country
2b	Fitting tool	1.860.882.000

3. Fit the timing driven pulley (3a) and secure it tightening the bolt (3b) to the recommended torque using tool (3c) supported by tool (3d) for counter-torque.

	Fastening	Component	Ø	Value(daNm)
3b	Bolt	TIMING GEAR DRIVEN PULLEYS	M10 x 1.25	7

	Name	Country
3c	Spanner for camshaft pulley rotation	1.860.831.002

	Name	Country
3d	Support for counter-torque	1.860.831.000

1. Check that the valve clearance, with the valves in the closed position, is within the recommended values.

	Measurement		Value
1	Inlet valve clearance (mm)		0.40 ± 0.05

	Measurement		Value
1	Exhaust valve clearance (mm)		0.45 ± 0.05

If the valve clearance measured is not within the recommended values, replace the tappet adjustment shims as described below.1. Lower the tappet in question using tool (1a) and keep it lowered using tool (1b).

	Name	Country
1a	Lever	1.860.443.000

	Name	Country
1b	Lever	1.860.747.000

1. Extract the tappet adjustment shim (1a) using the tool (1b) and replace it with one of a suitable size.2. Remove the tool for keeping the tappets lowered.

	Name	Country
1b	Pliers	1.887.001.000

	Name	Country
2	Lever	1.860.747.000

Remove the cylinder head from the support tool and reposition the latter.

	Name	Country
-	Support	1.860.470.000