0010T62 BRAKE AND/OR CLUTCH FLUID - REPLACE. FLUID - INCLUDES. WASHING PIPES AND BLEEDING AIR - Lancia - Ypsilon - eLearn

2428828 - 0010T62 BRAKE and/or CLUTCH FLUID - Replace. fluid - Includes. washing pipes and bleeding air

Position the vehicle on the ramp.1. Remove the protective cap on the brake caliper bleed valve.2. Connect the collection system (pipe and reservoir) to the bleed valve on the brake caliper.3. Open the bleed valve on the brake caliper.Operate the brake pedal until all the fluid has come out.Repeat the above operations for the other brake caliper and the two rear brake cylinders.

Proceed with removal Refer to op.. 5530B10 battery - r+r . Proceed with removal Refer to op.. 5530B52 Battery DRIP TRAY/SUPPORT - R.R. . 1. Remove the cap on the bleed valve.2. Connect the collection system (pipe and reservoir) to the bleed valve on the master cylinder.3. Lift the retaining clip (3a) until the first click is heard and remove the pipe (3b) sufficiently to uncover the bleed hole.4. Connect the tool to the brake-clutch fluid reservoir.

	Name	Country
4	Anti-pollution	1.806.097.000

5. Slowly open the cock on the reservoir of the device and fill the brake-clutch systems with the specified fluid.

	Type	Component	Name	Qty.
5	Synthetic fluid	BRAKE-CLUTCH HYDRAULIC SYSTEM	TUTELA TOP 4	-

Wait until the air contained in the hydraulic brake-clutch systems has fully emerged.

During the bleeding, refill the brake fluid reservoir, as necessary.

The collected brake/clutch fluid must not be reused. The level should always be topped up with new fluid.

Close the bleed valves on the brake calipers/rear wheel cylinders and fit the protective caps.Fit the pipe fully home in its seat on the clutch operating cylinder and secure with the retaining clip.Remove the fluid collection devices.Place the cap in its housing on the bleed valve. Remove the equipment.

	Name	Country
-	Anti-pollution	1.806.097.000

Proceed with refitting Refer to op.. 5530B52 Battery DRIP TRAY/SUPPORT - R.R. . Proceed with refitting Refer to op.. 5530B10 battery - r+r . Remove the car from the ramps.Check the efficiency of clutch release, gear engagement and the braking system.

If, after having carried out the bleeding operation, the system is not fully operational, repeat the entire procedure after having waited several hours for the brake fluid to settle down in the system.