1060G22 CAM ANGLE SENSOR - R R - Lancia - Ypsilon - eLearn

2429050 - 1060G22 cam angle sensor - r r

) Position the vehicle on the ramp.Ensure that the ignition key is in OFF position, then disconnect the battery negative terminal (-).

	Name	Connector
-	Battery	A1B

1. Disconnect the electrical connection from the air flow meter.

	Name	Connector
1	Air flow meter	K41

2. Loosen the band and disconnect the the turbocharger air inlet sleeve from the rigid pipe, air flow meter side.

1. Remove the air filter (1a) complete with air flow meter (1b) by releasing from the underlying pins and then from the rear fastenings.

1. Disconnect the electrical connection from the cam angle sensor.

	Name	Connector
1	Timing sensor	K47

2. Undo the bolt (2a) and remove the cam angle sensor (2b).

Refitting ( Removing

) Place the cam angle sensor back in its housing and fix it using the bolt to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	CAM ANGLE SENSOR	M6	(Cylinder head side) 0.6 ÷ 0.8

Connect the electrical connection to the cam angle sensor.Replace the air filter, complete with air flow meter, in its housing.Connect the air intake sleeve to the turbocharger, air flow meter side, and tighten the band.Connect the electrical connection to the air flow meter.Connect the negative (-) battery terminal.Remove the car from the ramps.