2429105 - 1820B59 Hydraulic clutch circuit vibration DAMPER with inlet and outlet pipes - R.r.

Removing ( Refitting ) Position the vehicle on the ramp. Proceed with removal  - 5530B10  battery - r+r . Proceed with removal  - 5530B52  Battery DRIP TRAY/SUPPORT - R.R. . 1. Remove the cap on the bleed valve.2. Connect the collection system (pipe and reservoir) to the bleed valve on the clutch operating cylinder.3. Lift the retaining clip (3a) until the first click is heard and remove the pipe (3b) sufficiently to uncover the bleed hole.Let the hydraulic clutch system drain completely. Lift up the clip completely and disconnect the pipe from the clutch operating cylinder.1. Lift the retaining clip (1a) and disconnect the pipe (1b) from the clutch master cylinder. 1. Remove the clutch hydraulic circuit vibration damper with inlet and outlet pipes (1a) after releasing it from the band (1b). Refitting ( Removing ) Place the clutch hydraulic circuit vibration damper with inlet and outlet pipes back in its housing, then secure it with the band.Fit the pipe fully home in its seat on the clutch master cylinder and secure with the retaining clip.Fit the pipe fully home in its seat on the clutch operating cylinder and secure with the retaining clip. Proceed with refitting  - 0010T67  hydraulic clutch system bleed air . Proceed with refitting  - 5530B52  Battery DRIP TRAY/SUPPORT - R.R. . Proceed with refitting  - 5530B10  battery - r+r . Remove the car from the ramps.