2429201 - 3340B74 RIGID PIPE from connector to rear brakes . (one), left or right - R.R.
Removing
(
Refitting
)
Position the vehicle on the
ramp.Remove the protective cap on the rear brake
shoe control cylinder Connect the collection system (pipe and
reservoir) to the bleed valve on the rear brake shoe control cylinder.Loosen the bleed valve on the rear brake
shoe control cylinder and wait for the brake-clutch reservoir and pipes
to drain.
Proceed with removal
- 1040A70 submerged pump assembly
complete with level guage control - r + r
.
Proceed with removal
- 7040L22 REAR TRIM on TUNNEL
-R.R.
.
Proceed with removal
- 4450B08 right rear wheel r r
.
Proceed with removal
- 7055B45 right hand rear supplementary
wheel arch - r+r
.
Proceed with removal
- 1040A10 fuel tank - r + r and decant
fuel
.
1. Undo the connector (1a) and disconnect the rigid pipe from the
connector to the right rear brake (1b), rigid pipe from control
unit side.2. Release the rigid pipe from the connector to the rear brakes
from the attachments on the underbody.
Refitting
(
Removing
)
1. Refit the rigid pipe from connector to rear brakes (1a), connect
to the hose and tighten the connector (1b) to the recommended torque. | Fastening | Component | Ø | Value(daNm) |
|---|---|---|---|---|
| 1b | Connector | RIGID PIPE FROM CONNECTORS TO REAR BRAKES. | - | (Flexible pipe side) 1.4 ÷ 1.8 |
| Fastening | Component | Ø | Value(daNm) |
|---|---|---|---|---|
| 2b | Connector | RIGID PIPE FROM CONNECTORS TO REAR BRAKES. | - | (Pipe from control unit side) 1.4 ÷ 1.8 |
