2429238 - 4410D13 front suspension beam - r r
Removing
(
Refitting
)
Position the vehicle on the
ramp.
Proceed with removal
- 4450B12 front or rear wheels (two)
- r+r
.
Proceed with removal
- 1076B40 CENTRE exhaust PIPE
- R.R.
.
Proceed with removal
- 1008C30 power unit lower reaction
link r r
.
1. Loosen the bolts fixing the lower track control arms to the
steering knuckles.2. Disconnect the lower track control arms (2a) from the steering
knuckles using a suitable tool (2b).3. Undo the bolts fixing the steering box to the front suspension
crossmember.4. Position a hydraulic jack under the front suspension crossmember.5. Undo the bolts fixing the front suspension crossmember to the
bodyshell.6. Remove the front suspension crossmember (6a), complete with lower
track control arms (6b) and anti-roll bar (6c), lowering the hydraulic
jack.
Refitting
(
Removing
)
1. Place the front suspension crossmember (1a), complete with lower
track control arms (1b) and anti-roll bar (1c), back in its housing
using the hydraulic jack.2. Tighten the bolts (2a) and (2b) fixing the front suspension crossmember
to the bodyshell to the recommended torque. | Fastening | Component | Ø | Value(daNm) |
|---|---|---|---|---|
| 2a | Side bolt | ENGINE OR ROD ANCHORAGE BEAM | M12 | (Bodyshell side) 10.5 ÷11.6 |
| Fastening | Component | Ø | Value(daNm) |
|---|---|---|---|---|
| 2b | Rear bolt | ENGINE OR ROD ANCHORAGE BEAM | M12 | (Bodyshell side) 11.4 ÷ 12.6 |
| Fastening | Component | Ø | Value(daNm) |
|---|---|---|---|---|
| 4 | Bolt | STEERING BOX (RACK AND PINION) | M12 | (Front suspension crossmember side) 6.7 ÷ 7.4 |
| Fastening | Component | Ø | Value(daNm) |
|---|---|---|---|---|
| 5 | Bolt | FRONT SUSPENSION LOWER LEVER | M10 | (Hub steering knuckle side) 5.9 ÷ 7.2 |
