2429310 - 5040A57 evaporator inlet pipe - r r

Follow the safety instructions (See 5040 - Precautions)
Removing ( Refitting ) Place the vehicle on a lift. Drain the coolant (  - 0010T84  coolant for air conditioning system dehydrate and recharge ).  - 1048A10  air cleaner filtering element - replace - 4450B04  right front wheel r r - 7055B91  Right front WHEEL ARCH LINER - R.R. - 5040B14  air conditioner system multi-level pressure switch - r+r1. Undo the nut (1a) and disconnect the intermediate connector (1b) for the pipe between the condenser and the evaporator.
Seal the disconnected connectors, using suitable plugs, to prevent humidity and impurities from entering the system.
2. Disconnect the pipe (2a) from the retainers (2b).
1. Working on the right side of the engine compartment, undo the bolts (1a) and move the engine coolant expansion tank (1b) slightly. 2. Undo the bolt (2a) fixing the bracket (2b) for the evaporator inlet pipe (2c).3. Release the fuel pipes (3a) from the retainers (3b).
 - 5050B34  windscreen wiper arm/s complete with blade - r+r (right and left)  - 7210E22  R.R. WINDSCREEN BASE TRIM1. Undo the nut (1a) and disconnect the connector (1b) from the expansion valve (1c) (disconnection necessary to be able to extract the connector (2b)). 2. Undo the nut (2a) and disconnect the connector (2b) from the expansion valve.3. Remove the pipe (3a) from the condenser to the evaporator after having disconnected it from the retaining band (3b).
Refitting ( Removing ) Check that the pipe is not damaged and that there are no cracks which would affect the seal.
Replace the O-rings for the connectors. Only use green coloured seals, resistant to R134A coolant fluid. Lubricate the thread of the connectors using anti-freeze.
1. Place the pipe (1a) in position and connect it to the retaining band (1b).2. Connect the connector (2a) to the expansion valve and tighten the nut (2b) to the recommended torque.

FasteningComponentØValue(daNm)
2bNutCOOLANT SYSTEM FITTINGSM60.9
3. Connect the connector (3a) to the expansion valve and tighten the nut (3b) to the recommended torque.

FasteningComponentØValue(daNm)
2bNutCOOLANT SYSTEM FITTINGSM60.9
 - 7210E22  R.R. WINDSCREEN BASE TRIM - 5050B34  windscreen wiper arm/s complete with blade - r+r (right and left) Place the fuel pipes in position and secure them to the retainers. Tighten the bolt fixing the bracket for the evaporator inlet pipe.Place the engine coolant expansion tank in position and secure it using the bolts.1. Connect the pipe (1a) to the retainers (1b).2. Connect the connector (2a) for the evaporator inlet pipe, condenser side, and secure it tightening the nut (2b) to the recommended torque.

FasteningComponentØValue(daNm)
2bNutCOOLANT SYSTEM FITTINGSM60.9
 - 5040B14  air conditioner system multi-level pressure switch - r+r - 7055B91  Right front WHEEL ARCH LINER - R.R. - 4450B04  right front wheel r r - 1048A10  air cleaner filtering element - replace Repressurize using coolant fluid (  - 0010T84  coolant for air conditioning system dehydrate and recharge ). Remove the vehicle from the lift.