1. Lift up the backrest cover (1a) slightly and release the retaining
duct (1b) from the frame profile (1c).
1. Lift up the cover (1a) and release it from the head restraint
guide bushes (1b).2. Keep the cover and upholstery.
1. Disconnect the velcro for the cover from the upholstery.2. Release the cover from the perimeter of the upholstery.3. Using a screwdriver, release the retainers (3a) from the cover
metal wire (3b), then separate the cover (3c) from the upholstery
(3d).
1. Using a screwdriver, release the retainer (1a) and extract all
the head restraint guide bushes (1b) releasing the positioning tab
(1c) from the housing (1d).
Refitting
(
Removing
)
Check that the cover is undamaged.1. Position the backrest cover (1a) and fit the head restraint guide
bushes (1b) in position.
Attach the retainers to the
metal wire for the upholstery.Carefully fit the cover on the upholstery
and attach the velcro.Attach the retaining duct to the profile
of the frame.1. To close the zip fastening (1a), use the zip (1b) after having
removed the hooks (1c) using pliers. 2. After having closed the zip fastenings (1a), (1d), (1e), in order
to prevent them being opened accidentally, fit the retaining hooks
(1c) and (1g) to the ends of the actual zip fastenings.
Removing
(
Refitting
)
- 7050A10 rear seat - r+r - 7050A87 JOINT COVER GUARD for (one), left or right individual
seat - R.R. with seat removed - 7050B12 rear seat head restraint - r r
(all)
1. Undo the bolts (1a) and remove the trims (1b) at the back of
the backrest cover.2. Using the side zip fastenings (2a) completely open the side sections
(2b) of the backrest cover. 3. Using pliers, remove the end clip (3a) then open the lower zip
fastening (3b) along the entire lower section (3c) of the backrest
cover. 
