1. Lift up the cover (1a) and release it from the head restraint
guide bushes (1b).2. Keep the cover and upholstery.
1. Release the cover from the perimeter of the upholstery.2. Using a screwdriver, release the retainers (2a) from the metal
wire (2b) for the cover, then separate the cover (2c) from the upholstery
(2d).
1. Using a screwdriver, release the retainer (1a) and extract the
head restraint guide bushes (1b) releasing the positioning tab (1c)
from the housing (1d).
Refitting
(
Removing
)
Check that the cover is undamaged.1. Position the backrest cover (1a) and fit the head restraint guide
bushes (1b) in the housing.
Attach the retainers for the
metal wire for the upholstery.Carefully fit the cover on the upholstery.Attach the retaining duct to the profile
of the frame.1. To close the zip fastening (1a), use the zip (1b) after having
removed the hooks (1c) using pliers. 2. After having closed the zips (1a), (1d), (1e), to prevent them
from opening accidentally, fit the retaining hooks (1c) and (1g)
to the ends of the actual zip fastenings.
Removing
(
Refitting
)
- 7050A87 JOINT COVER GUARD for
(one), left or right individual seat - R.R. with seat removed - 7050B12 rear seat head restraint - r r1. Undo the bolts (1a) and remove the trims (1b) at the back of
the backrest cover.2. Using the zip fastenings (2a), completely open the side sections
(2b) of the backrest cover. 3. Using pliers, remove the hook (3a) then open the lower zip fastening
(3b) along the entire lower section (3c) of the backrest cover. 
