7210E66 R.R. REAR BUMPER - Lancia - Ypsilon - eLearn

2429742 - 7210E66 R.R. REAR BUMPER

) Place the car on the ramp. - 5540A44 l/h or r/h tail light (one) - r+r (right and left) 1. Raise the vehicle and unscrew the side screws from both sides.2. Move trim (2a) slightlly and unscrew bolt (2b).

1. Unscrew the lower bolts.2. Disconnect the electrical sensors from the obstacle detection sensors.

	Name	Connector
2	Parking sensor coupling	D89

1. Lower the vehicle and unscrew the upper bolts.2. Remove the bumper.

If necessary, remove the following parts. - 5580H36 parking sensor system rear sensor (1), lh or rh - r r - 5580H06 wiring of parking sensor system r r

Refitting ( Removing

) Check that the rear bumper is undamaged.Position the bumpers and check alignment.Tighten the upper bolts.Raise the vehicle and connect the electrical connection.Tighten the lower bolts.Tighten the side bolts and arrange the trim. - 5540A44 l/h or r/h tail light (one) - r+r (right and left)