7045A13 FRONT SEAT WITH SIDE BAG R R - Lancia - Ypsilon - eLearn

2429607 - 7045A13 front seat with side bag r r

) 1. Move the seat fully forward and undo the rear bolts.

1. Move the seat fully back and undo the front bolts.2. Release the retainer (2a) and rotate the connector support (2b) into an accessible position.3. Disconnect the electrical connection.

	Name	Connector
3	Driver's Side Bag	Q30

	Name	Connector
3	Passenger Side Bag	Q31

4. Remove the seat.

Refitting ( Removing

) Check that the seat and the guides are not damaged.1. Connect the electrical connections .2. Rotate the connector mounting bracket and engage the retainer.3. Place the seat (3a) in its housing on the floor of the vehicle. Ensure it is fully back on the guides and engage locating pin (2b).

Check that the carpet is not fouling against the guide support areas. Work with due caution so as not to damage the plastic parts.

1. Screw on and tighten the inner front bolt.

	Fastening	Component	Ø	Value(daNm)
1	Bolt	FRONT SEAT ASSEMBLY.	M8	2.5

2. Screw on and tighten the outer front bolt.

	Fastening	Component	Ø	Value(daNm)
2	Bolt	FRONT SEAT ASSEMBLY.	M8	2.5

The seat must be fixed to the floor without suffering distortion on the guides. If necessary, adjust the floating nuts (1b) making sure that they are free.

Slide the seat fully forward. Check that the elements for both guides engage simultaneously. 1. Screw on and tighten the outer rear bolt.

	Fastening	Component	Ø	Value(daNm)
1	Bolt	FRONT SEAT ASSEMBLY.	M8	2.5

2. Screw on and tighten the inner rear bolt.

	Fastening	Component	Ø	Value(daNm)
2	Bolt	FRONT SEAT ASSEMBLY.	M8	2.5

At this stage, do not raise the seat to gain access to the bolt; the bracket is slotted.

3. Check that the seat slides correctly. If there is lengthwise clearance for the guide attachment, loosen the outer bolts; slide the seat several times, then tighten the bolts to the recommended torque.