| | Results of the tests |
| 0 | PRELIMINARY CHECK | All OK | Problems met | Operation |
|---|
| Connect the EXAMINER diagnostic equipment and
check the CAN NETWORK INFORMATION: - For inactive control units
- For control units with errors
- For CAN control units with errors
| Continue to Step 1 | Presence of faults in
the CAN | Continue as instructed by the tester |
| Impossible to converse with the Body Computer 1. Continue following
the instructions given by the diagnostic equipment | Continue to Step 7 |
| 1 | CHECK WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|
| Keep the tester connected and check
the BRAKE NODE for: - System/component faults
- CAN faults
| Continue to Step 2 | System/component faults | Continue as instructed by
the tester |
| Presence of C-CAN faults | Continue to Step 9 |
| 2 | CHECK WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|
| Using
the Examiner check, in the Instrument Panel Node ambient, that there
are no errors and the following parameters are present. | Continue to Step 3 | There are errors | Continue in accordance with
the instructions for the diagnostic equipment |
| 3 | ELECTRIC POWER SUPPLY CHECK | All OK | Problems met | Operation |
|---|
| Check
that the Instrument Panel Node electrical power supply is correct. | Continue to Step 4 | Positive and/or earth
electrical power supply fault. | Replace the defective component (if a fuse
is involved, search for the cause of the problem). |
| 4 | CHECK ELECTRICAL CONNECTIONS | All OK | Problems met | Operation |
|---|
| Check
the electrical connections between the Body Computer and the Instrument
Panel, in particular that each individual pin is correctly connected. | Continue to Step 5 | Electrical connections
not working. | Restore damaged electrical connection. |
| 5 | CHECK ELECTRICAL CONNECTIONS | All OK | Problems met | Operation |
|---|
| With
the Examiner in the Instrument Panel Node ambient, check, in active
diagnosis, that the ABS warning light is correctly activated | Continue to Step 6 | The ABS warning light does
not flash | Replace the instrument panel Op. 5560B11 |
| 6 | CHECK WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|
| Using
the Examiner, check, in the Body Computer Node ambient, that there
are no errors and that the warning light status varies | Continue to Step 9 | Impossible to connect
with the Body Computer control unit. | Continue to Step 7 |
| Errors present. | Continue according to the instructions for the diagnostic
equipment. |
| The parameter values do not change | Continue to Step 9 |
| 7 | ELECTRIC POWER SUPPLY CHECK | All OK | Problems met | Operation |
|---|
| Check
that the Body Computer Node electrical power supply is correct. | Continue to Step 8 | Positive and/or earth
electrical power supply fault. | Replace the defective component (if a fuse
is involved, search for the cause of the problem). |
| 8 | CHECK WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|
| Using
the Examiner, check the possibility of connecting with the Body
Computer Node. | Continue to Step 6 | Impossible to connect
with the Body Computer control unit. | Replace the Body Computer Op. 5505A32 |
| 9 | CHECK ON CORRECT OPERATION | All OK | Problems met | Operation |
|---|
| Check
that the fault is no longer present | End of diagnosis | Fault persists | Replace the Body Computer Op. 5505A32 |
