L17 CLIMATE CONTROL RECIRCULATION AUTOMATIC MODE NOT WORKING - Lancia - Ypsilon - eLearn

The recirculation is not closed in automatic mode when there is pollutaion.

0	PRELIMINARY CHECK	All OK	Problems met	Operation
		Results of the tests
	Check: that the flap works when the recirculation button is pressed	Continue to Step 1	Motor not working	Continue to Step 2
1	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the examiner and check for errors at the climate control node.Carry out the recirculation motor test in active diagnosisIf it is not activated, check the recirculation motor wiring	Continue to Step 2	Faulty wiring	Renew the wiring
2	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the Examiner diagnostic equipment : check that the recirculation flap is working properly in automatic mode by selecting active diagnosis and carrying out the 'pollution sensor test'. If the result is negative, carry out See Test 5040DD Check on pollution sensor signal	Continue to Step 3	Passenger compartment air pollution sensor defective	Replace sensor
		Continue to Step 3	Passenger compartment air pollution sensor defective	Renew the wiring
3	CHECK ON CORRECT OPERATION	All OK	Problems met	Operation
	Check that the recirculation flap is working properly by carrying out the 'pollution sensor test' again with the Examiner in Active DiagnosisCheck that the fault is no longer present	End of diagnosis	Fault persists	Replace the climate control system control unit