3340A34 RPM SENSOR (ONE) OF ONE L/H OR R/H REAR WHEEL - R+R - Lancia - Ypsilon - eLearn

2429191 - 3340A34 rpm sensor (one) of one l/h or r/h rear wheel - r+r

) .

The following procedure describes removal/refitting of the left rear wheel rpm sensor; proceed as for the right rear wheel rpm sensor.

Position the vehicle on the ramp.Ensure that the ignition key is in OFF position, then disconnect the battery negative terminal (-).

	Name	Connector
-	Battery	A1B

1. Undo the bolt (1a) and remove the rear wheel rpm sensor (1b).2. Release the rear wheel rpm sensor electrical wiring from the attachments on the rear suspension.

1. Disconnect the electrical connection for the rear wheel rpm sensor.

	Name	Connector
1	Left rear wheel sensor for ABS.	K75

	Name	Connector
1	Right rear wheel sensor for ABS.	K76

2. Remove the right front wheel rpm sensor after releasing the electrical wiring from the underbody fastenings.

Refitting ( Removing

) Connect the electrical connection for the rear wheel rpm sensor.Secure the rear wheel rpm sensor electrical wiring to the underbody fastenings.Place the rear wheel rpm sensor back in its housing and fix it tightening the bolt to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	ABS REAR WHEEL RPM SENSOR	M6	0.6 ÷ 0.8

Secure the rear wheel rpm sensor electrical wiring to the rear suspension fastenings.Connect the negative (-) battery terminal.Remove the car from the ramps.