3330B02 PEDAL ASSEMBLY - R R - Lancia - Ypsilon - eLearn

2429167 - 3330B02 pedal assembly - r r

) Ensure that the ignition key is in OFF position, then disconnect the battery negative terminal (-).

	Name	Connector
-	Battery	A1B

Proceed with removal - 1068A20 accelerator pedal with built-in potentiometer - r r . Proceed with removal - 7040A30 Left instrument panel lower TRIM - R.R. . Undo both bolts and remove the underfacia beam lower reinforcement.

For versions with VDC, before disconnecting the steering column universal joint, put on the steering lock to prevent rotation.

1. Release the steering column universal joint (1a) by undoing the bolt (1b) securing it to the steering box.

The bolt is pretreated and cannot therefore be refitted.

Proceed with removal - 1056B78 SWITCH on CLUTCH PEDAL - R.R. . Proceed with removal - 5550D10 brake light switch - r+r .

Refitting ( Removing

) 1. Fit the pedal assembly (1a) back in its housing and tighten the nuts (1b) to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Nut	PEDALS	M8	(Brake servo/bodyshell side) 1.8 ÷ 2.6

Connect the clutch pedal by replacing in its seat and press the pedal fully down.1. Fit the new retaining device (1a) onto brake pedal (1b) to secure the retaining clips (1c). Position the cover (1d) for the brake servo push rod spherical head.

After each dismantling operation the black coloured retaining device (1a) for the brake servo push rod must always be replaced even if it appears to be intact.

Lift up the brake pedal and position the brake servo push rod by the retaining device.Press the brake pedal to engage the brake servo push rod with the retaining device. Proceed with refitting - 5550D10 brake light switch - r+r . Proceed with refitting - 1056B78 SWITCH on CLUTCH PEDAL - R.R. . 1. Connect the steering column universal joint (1a) and fasten it tightening the bolt (1b) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1b	Bolt	INTERMEDIATE SHAFT CONNECTED TO STEERING BOX.	M10	(Steering box side) 5.0 ÷ 6.1

Refit the underfacia beam lower reinforcement and tighten the bolts Proceed with refitting - 7040A30 Left instrument panel lower TRIM - R.R. . Proceed with refitting - 1068A20 accelerator pedal with built-in potentiometer - r r .