3237518 - 1040A70 submerged pump assembly complete with level guage control - r + r

When scrapping the submerged pump assembly with level gauge mechanism, always empty of fuel as follows:

  • while removing the submerged pump assembly, draw off any fuel in the tank using an in-line pump (electric or manual);
  • fully remove the submerged pump assembly then, working at the bench, connect an in-line pump (electric or manual) to the assembly connector;
  • run the pump for as long enough to collect most of the petrol present inside the filter.

When scrapping the submerged pump assembly with level gauge mechanism, always empty of fuel as follows:

  • while removing the submerged pump assembly, draw off any fuel in the tank using an in-line pump (electric or manual);
  • fully remove the submerged pump assembly then, working at the bench, connect an in-line pump (electric or manual) to the assembly connector;
  • run the pump for as long enough to collect most of the petrol present inside the filter.

For cars fitted with returnless system, when scrapping the submerged pump assembly with level gauge mechanism, always empty of fuel as follows:

  • while removing the submerged pump assembly, draw off any fuel in the tank using an in-line pump (electric or manual);
  • fully remove the submerged pump assembly then, working at the bench, connect an in-line pump (electric or manual) to the assembly connector;
  • run the pump for as long enough to collect most of the petrol present inside the filter.

When scrapping the submerged pump assembly with level gauge mechanism, always empty of fuel as follows:

  • while removing the submerged pump assembly, draw off any fuel in the tank using an in-line pump (electric or manual);
  • fully remove the submerged pump assembly then, working at the bench, connect an in-line pump (electric or manual) to the assembly connector;
  • run the pump for as long enough to collect most of the petrol present inside the filter.
Removing ( Refitting )  - 7050B18  rear seat arm rest - r+r Make sure that the ignition is off (STOP position), then disconnect the negative battery terminal (refer to op.   5530B10  battery - r+r ).

NameConnector
-Battery  A1B 
1. Undo the nuts (1a) and remove the access cover (1b) to the immersed pump assembly complete with gauge. 2. Disconnect the electrical connection from the immersed pump assembly complete with gauge.

NameConnector
2Fuel pump and sender unit  N40 
3. Disconnect the fuel supply and return pipe couplings from the immersed pump assembly complete with gauge.
1. Undo the right nut (1a) fixing the immersed pump assembly complete with gauge using the tool (1b).

NameCountry
1bKey1.822.135.000
2. Remove the immersed pump assembly complete with gauge.
Refitting ( Removing ) 1. Fit the immersed pump assembly complete with gauge so that the arrow stamped on the cover is in line with the one on the tank.
Fit the ring nut fixing the immersed pump assembly complete with gauge and tighten it using the tool.

NameCountry
-Key1.822.135.000
Connect the fuel supply and return pipe couplings to the immersed pump assembly complete with gauge. Connect the electrical connection to the immersed pump assembly complete with gauge. Fit the access cover to the immersed pump assembly complete with gauge and fix it using the nuts. Connect the negative (-) battery terminal - 7050B18  rear seat arm rest - r+r