1088B20 ENGINE COOLING RADIATOR - R + R - Alfa - 156 - eLearn

3237708 - 1088B20 engine cooling radiator - r + r

) Position the vehicle on the ramp.Ensure that the ignition key is in OFF position, then disconnect the negative battery terminal.

	Name	Connector
-	Battery	A1B

1. Disconnect the electrical connections from the engine cooling fan resistor.

	Name	Connector
1	Engine fan adjustment resistor - 1	O10

2. Disconnect the electrical connection from the radiator cooling fan motor (2a) and release the electrical wiring from the band (2b).

	Name	Connector
2a	Engine fan motor - 1	N11

Proceed with removal - 7055B54 under-engine guard - r r . 1. Disconnect the lower coolant outlet hose from the radiator and drain the engine coolant.

Manually press the springs and remove the rapid attachment for the hose.

Collect the coolant using a suitable container.

1. Loosen band and disconnect the upper coolant inlet hose to the radiator, radiator side.

Proceed with removal - 7210E10 R.R. FRONT BUMPER . 1. Undo the upper bolt fixing the engine cooling radiator to the bodyshell.

1. Undo the bolts fixing the air duct to the engine cooling radiator.

1. Undo the bolts fixing the air conditioning system condenser to the engine cooling radiator.

Fasten the air conditioning system condenser to the bodyshell.

1. Position a hydraulic jack under the radiator lower crossmember.2. Undo the bolts securing the radiator bottom crossmember to the bodywork.3. Lower the hydraulic jack and remove the lower radiator crossmember (3a), complete with engine cooling radiator (3b) and radiator cooling fan.

Refitting ( Removing

) Place the lower radiator crossmember complete with engine cooling radiator and radiator cooling fan back in its housing using the hydraulic jack.Tighten the bolts securing the radiator bottom crossmember to the bodywork.Remove the hydraulic jack from underneath the lower radiator crossmember.Tighten the bolts fixing the air conditioning system condenser to the engine cooling radiator.Release the air conditioning system condenser from the temporary fastening on the bodyshell.Tighten the bolts fixing the air duct to the engine cooling radiator.Tighten the upper bolt fixing the engine cooling radiator to the bodyshell. Proceed with refitting - 7210E10 R.R. FRONT BUMPER . Connect the upper coolant inlet hose to the radiator, radiator side, and tighten the band.Connect the rapid attachment for the bottom coolant outlet hose from the radiator. Proceed with refitting - 7055B54 under-engine guard - r r . Connect the electrical connection to the radiator cooling fan motor and secure the electrical wiring to the band.Connect the electrical connections to the resistor for the engine cooling fan.Connect the negative (-) battery terminal. Refill the engine cooling system with coolant - 0010T20 coolant change . Remove the car from the ramps.