1088D24 RIGID PIPE FOR COOLANT INLET TO WATER PUMP - R + R - Alfa - 156 - eLearn

3237711 - 1088D24 rigid pipe for coolant inlet to water pump - r + r

) Position the vehicle on the ramp. Proceed with removal - 5530B10 battery - r+r . Drain the air conditioner coolant circuit - 5040A10 Air conditioning refrigerant CIRCUIT - Draining and Refilling . Proceed with removal - 4450B04 right front wheel r r . Proceed with removal - 7055B54 under-engine guard - r r . Proceed with removal - 5040A20 air conditioner compressor - r+r - includes fluid level check and top up if necessary . Proceed with removal - 5040A26 compressor mount - r r . 1. Disconnect the lower coolant outlet hose from the radiator and drain the engine coolant.

Manually press the springs and remove the rapid attachment for the hose.

Collect the coolant using a suitable container.

Proceed with removal - 1016A40 ignition coil cover on cylinder head- r+r . Proceed with removal - 1076A48 catalytic converter heat shield - r r . 1. Loosen band and disconnect the upper coolant inlet hose to the radiator thermostat side.2. Loosen the band and disconnect the coolant outlet pipe from the climate control heater, water pump rigid inlet pipe side. 3. Loosen the band securing the coolant outlet pipe from the engine oil heat exchanger on the water pump rigid inlet pipe side.

1. Loosen the band and disconnect the engine coolant supplyj sleeve, water pump rigid inlet pipe side.2. Undo the bolt securing the guide tube for the engine oil dipstick to the water pump rigid fluid inlet pipe.

1. Undo the bolts (1a) and remove the water pump rigid inlet pipe (1b) complete with lower coolant outlet pipe from the radiator (1c) after disconnecting the coolant outlet pipe from the engine oil heat exchanger from the radiator. 2. Remove the O-ring.

Refitting ( Removing

) Refit the water pump rigid inlet pipe, complete with lower coolant outlet sleeve from the radiator and O-ring and secure it using the bolts. Tighten the bolt securing the engine oil dipstick guide tube to the water pump fluid rigid fluid intake pipe.Connect the engine coolant supply sleeve, water pump rigid inlet pipe side, to the water pump and tighten the band.Connect the coolant outlet pipe from the engine oil heat exchanger to the water pump rigid inlet pipe and tighten the band.Connect the coolant return hose from the climate control heater on the side of the rigid inlet pipe to the water pump and tighten the pump.Connect the upper coolant inlet hose to the radiator, thermostat side, and tighten the band. Proceed with refitting - 1076A48 catalytic converter heat shield - r r . Proceed with refitting - 1016A40 ignition coil cover on cylinder head- r+r . Connect the rapid attachment for the bottom coolant outlet hose from the radiator. Proceed with refitting - 5040A26 compressor mount - r r . Proceed with refitting - 5040A20 air conditioner compressor - r+r - includes fluid level check and top up if necessary . Proceed with refitting - 7055B54 under-engine guard - r r . Proceed with refitting - 4450B04 right front wheel r r . Fill the air conditioner coolant circuit - 5040A10 Air conditioning refrigerant CIRCUIT - Draining and Refilling . Proceed with refitting - 5530B10 battery - r+r . Refill the engine cooling system with coolant - 0010T20 coolant change . Remove the car from the ramps.