3237719 - 1092E22 counter-rotating shaft drive toothed belt drive pulley - r + r

Removing ( Refitting ) Place the car on the lifting bridge. - 7055B54  under-engine guard - r r- 4450B80 cap of one wheel - r+r  - 4450B10  Front WHEEL (one) - R.R. - 7055B64  Engine compartment DUST shield in front wheel arch (one), left or right - R.R. - 1092G10  single engine belt r r - 1092G20  engine component single belt fixed tensioner - one - r + r - 1092A10  Crankshaft services PULLEY - R.R. - 1032D12  timing system protective cover(s) - r + r - 1092E10  counter-rotating shaft drive toothed belt - r + r1. Unscrew screws (1a) of counter-rotating shaft toothed belt drive pulley (1b) and remove it.
Refitting ( Removing ) Fit counter-rotating shaft toothed belt drive pulley and fix it with its screws.

FasteningComponentØValue(daNm)
-BoltCOUNTER-ROTATING SHAFT DRIVE PULLEYM62.5
End by carrying out the following operations: - 1092E10  counter-rotating shaft drive toothed belt - r + r - 1032D12  timing system protective cover(s) - r + r - 1092A10  Crankshaft services PULLEY - R.R. - 1092G20  engine component single belt fixed tensioner - one - r + r - 1092G10  single engine belt r r - 7055B64  Engine compartment DUST shield in front wheel arch (one), left or right - R.R. - 4450B10  Front WHEEL (one) - R.R.- 4450B80 cap of one wheel - r+r  - 7055B54  under-engine guard - r r Removing ( Refitting ) Position the vehicle on the ramp.Ensure that the ignition key is in OFF position, then disconnect the negative battery terminal.

NameConnector
-Battery  A1B 
Proceed with removal  - 4450B04  right front wheel r r . Proceed with removal  - 7055B54  under-engine guard - r r . Proceed with removal  - 1016A40  ignition coil cover on cylinder head- r+r . Proceed with removal  - 1092E10  counter-rotating shaft drive toothed belt - r + r . 1. Undo the bolts (1a) and remove the counter-balance shaft drive belt drive pulley (1b).
Refitting ( Removing ) Place the counter-balance shaft drive belt drive pulley back in its housing and secure it tightening the bolts to the recommended torque.

FasteningComponentØValue(daNm)
-BoltCOUNTER-ROTATING SHAFT DRIVE PULLEYM6(Timing drive pulley side.) 0.8÷1.0
Proceed with refitting  - 1092E10  counter-rotating shaft drive toothed belt - r + r . Proceed with refitting  - 1016A40  ignition coil cover on cylinder head- r+r . Proceed with refitting  - 7055B54  under-engine guard - r r . Proceed with refitting  - 4450B04  right front wheel r r . Connect the negative (-) battery terminal.Remove the vehicle from the lift.