4420B16 FRONT WISHBONE - R R - Alfa - 156 - eLearn

3238201 - 4420B16 front wishbone - r r

) Position the vehicle on the ramp.Raise the vehicle. - 4450B11 WHEEL (one) rear - R.R.1. Undo the nut (1a) and withdraw bolt (1b) as far as necessary to disconnect front wishbone (1c) from the damper.2. Loosen the bolt (2a) securing the rear suspension longitudinal strut (2b) to the hub stub axle.3. Loosen the nut (3a) and remove the rear suspension front track control arm (3b).

Refitting ( Removing

) Fit the rear suspension front track control arm and secure it to the rear suspension crossmember tightening the bolt to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR SUSPENSION FRONT WISHBONES	M12	(Crossmember side) 9.5 ÷ 11.6

Tighten the bolt securing the rear suspension tie rod to the stub axle to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR ANCHORAGE ROD	M12	11.7 - 12.9

Connect front wishbone to the damper and secure by tightening bolt to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR WISHBONE	M12	(Shock absorber side) 9.5 ÷ 11.6

- 4450B11 WHEEL (one) rear - R.R.Lower the vehicle.Remove the car from the ramp. Check and if necessary adjust the wheel geometry values - 4450A40 rear wheel geometry - check using optical equipment .