4420D42 REAR SUSPENSION BEAM - R R - Alfa - 156 - eLearn

3238213 - 4420D42 rear suspension beam - r r

) Position the vehicle on the ramp.Raise the vehicle.1. Undo the bolts (1a) and disconnect the suspension rams (1b) from the rear suspension crossmember.2. Undo the bolts securing the anti-roll bar to the rear suspension crossmember.3. Position a hydraulic jack under the rear suspension crossmember.4. Undo the bolts (4a) and remove the rear suspension crossmember (4b) using the hydraulic jack.

Refitting ( Removing

) Place the rear suspension crossmember back in its housing using the hydraulic jack and fix it tightening the bolts to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR CROSS-BEAM	M10	6.2 - 6.8

Remove the hydraulic jack from under the rear suspension crossmember.Tighten the bolts securing the anti-roll bar to the rear suspension crossmember to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR ANTI-ROLL BAR	M6	0.7 - 0.8

Connect the track control arms to the rear suspension crossmember and secure them tightening the bolts to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR WISHBONE	M12	11.7 - 12.9

Lower the vehicle.Remove the vehicle from the ramp. Check and, if necessary, adjust the wheel geometry - 4450A40 rear wheel geometry - check using optical equipment .