3237598 - 1080E24 fuel vapour by-pass valve/solenoid - r + r

Removing ( Refitting ) Disconnect the battery negative terminal.

	Name	Connector
-	Battery	A1B

 - 4450B10  Front WHEEL (one) - R.R. - 7055B42  Additional FRONT WHEEL ARCH (one), left or right - R.R.1. Disconnect the electrical connection from the fuel vapour cut out valve.

	Name	Connector
1	Fuel vapour recovery solenoid	L10

2. Release the bands, disconnect the inlet/outlet pipes and remove the valve from its housing. Refitting ( Removing ) Fit the fuel vapour cut out valve in its housing.

The arrow on the valve should be facing the right front headlamp.

Connect the inlet/outlet pipes tightening the bands.Connect the electrical connection to the cut out valve. - 7055B42  Additional FRONT WHEEL ARCH (one), left or right - R.R. - 4450B10  Front WHEEL (one) - R.R.Connect the battery negative terminal. Removing ( Refitting ) Place the car on a lift. - 1048A34  sleeve(s) from flow meter to air supply capacity case - r + r1. Disconnect the electrical connection for the fuel vaopur cut out valve.

	Name	Connector
1	Fuel vapour recovery solenoid	L10

2. Undo the two fixing bolts on the chamber.3. Release it from the flexible pipes and remove it from the engine compartment. Refitting ( Removing ) Reconnect the valve to the flexible pipes.Tighten the two fixing bolts.Reconnect the electrical connection. - 1048A34  sleeve(s) from flow meter to air supply capacity case - r + r