4130B74 RETURN PIPE BETWEEN POWER STEERING CASE AND DUPLEX PIPES R R - Alfa - 156 - eLearn

3238148 - 4130B74 return pipe between power steering case and duplex pipes r r

) Position the vehicle on the rampRemove the power steering fluid reservoir and drain the fluid using a suitable syringe. - 4450B10 Front WHEEL (one) - R.R. (Right side). - 7055B64 Engine compartment DUST shield in front wheel arch (one), left or right - R.R. . 1. Undo the nuts (1a) and release the power steering pipes (1b) from the mounting bracket.

- 7055B54 under-engine guard - r r . - 1076B50 exhaust pipe attachment to engine - r + r . 1. Undo the connecctor (1a) and disconnect the rigid return pipe between the power steering box and heat exchanger (1b), power steering box side.

Recover the power steering fluid which comes out in a suitable container.

2. Release the rigid return pipe between power steering box and heat exchanger from the retaining bands.

1. Undo the nut securing the power steering pipes to the crossmember and remove the band.

1. Disconnect the rapid attachment coupling on the rigid return pipe between power steering box and heat exchanger.

1. From the wheelarch, withdraw and remove the rigid return pipe between the power steering box and heat exchanger.

Refitting ( Removing

) Replace the rigid return pipe between power steering box and heat exchanger in its seating.Connect the rapid attachment coupling of the rigid return pipe between the power steering box and heat exchanger.Secure the power steering pipes to the crossmember with the relevant band and tighten the nut.Fix the rigid return pipe between power steering box and heat exchanger to the band.Connect the rigid return pipe between power steering box and heat exchanger, power steering box side, and tighten the relevant connector to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Connector	POWER STEERING BOX/EXCHANGE RIGID PIPE	M12	(Power steering box side) 2.8 - 3.2

- 1076B50 exhaust pipe attachment to engine - r + r . - 7055B54 under-engine guard - r r . Secure the power steering pipes to the mounting bracket and tighten the nuts. - 7055B64 Engine compartment DUST shield in front wheel arch (one), left or right - R.R. . - 4450B10 Front WHEEL (one) - R.R. (Right side). Top up the power assisted circuit with the recommended fluid.

	Type	Component	Name	Qty.
-	Fluid	HYDRAULIC POWER ASSISTED STEERING SYSTEM	TUTELA GI/A	1.3

Fluid for Northern European countries: TUTELA CAR GI/E - ATF DEXRON III.

Bleed the power steering system as described belowWith the front wheels raised off the ground, with the engine switched off turn the steering wheel to full lock, left and right, 4-5 times. Check and, if necessary, top up the fluid level in the reservoir. Remove the car from the ramps.Start the engine and turn the steering wheel to full lock, left and right, 4 - 5 times.Top up the fluid level in the reservoir.