3237428 - 0510C10 fuel system - check delivery pressure

Disconnect the fuel supply pipe from the distribution manifold.1. Connect a pressure gauge between the manifold and the disconnected pipe using a 'T' adaptor.Disconnect the vacuum intake pipe from the fuel pressure regulator to prevent uneven idling leading to irregular readings.Start the engine and leave to idle. Check that the fuel pressure is within the specified range.

	Measurement		Value
-	Idle speed fuel pressure (bar)		2.3 - 2.7

Re-connect the vacuum intake pipe to the regulator. Check that the fuel pressure drops by ~ 0.5 bar and then rises again when the throttle valve is opened. If this does not occur, check for leaks in the vacuum pipe.Keep the vacuum intake pipe connected to the regulator and leave the engine to idle. Pinch the fuel outlet pipe from the distribution manifold so that the pressure rises to ~ 4 bar (do not allow the pressure to exceed this value).Disconnect the pressure gauge and the 'T' adaptor.Connect the fuel inlet pipe to the distribution manifold. 1. Connect the equipment to the distribution manifold bleed valve and discharge the fuel pressure.

	Name	Country
1	Rapid connector	1.870.684.000

2. Disconnect the fuel supply pipe from the distribution manifold.3. Fit the tools (3a) and (3b) on the tool (3c).

	Name	Country
3a	Connectors kit	1.860.955.003

	Name	Country
3b	Connectors kit	1.860.955.001

	Name	Country
3c	Pressure gauge	1.860.955.000

Connect the newly-prepared tool to the fuel supply pipe and distribution manifold.4. Open the ball valve.5. Open the ball valve.6. Close the ball valve.Start the engine and leave to idle. Check that the fuel pressure is within the specified range.

	Measurement		Value
-	Idle speed fuel pressure (bar)		3.3 - 3.7

Switch off the engine. Disconnect the test equipment from the distribution manifold and fuel supply pipe.Connect the fuel supply pipe to the fuel manifold.