3238023 - 2710A32 intermediate drive shaft bearing support - r + r with intermediate drive shaft removed

Removing ( Refitting ) Position the vehicle on the rampEnsure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	A1B

 - 7055B54  under-engine guard - r r . - 4450B80 cap of one wheel - r+r .  - 4450B10  Front WHEEL (one) - R.R. .  - 7055B64  Engine compartment DUST shield in front wheel arch (one), left or right - R.R. .  - 1092G10  single engine belt r r . 1. Disconnect the electrical connections from the alternator.

	Name	Connector
1	Alternator	A10

1. Undo the bolts (1a) and move alternator (1b) from the mount. 1. Undo the bolts (1a) and remove the intermediate drive shaft bearing mounting (1b). Refitting ( Removing ) Fit the intermediate drive shaft bearing and tighten the bolts to the specified torque to secure.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	FRONT DRIVE SHAFT BEARING MOUNT	M8	2.5

	Fastening	Component	Ø	Value(daNm)
-	Bolt	FRONT DRIVE SHAFT BEARING MOUNT	M10	7.0

Fit the alternator and fix it tightening the bolts to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	ALTERNATOR ASSEMBLY	M10	7.0

	Fastening	Component	Ø	Value(daNm)
-	Bolt	ALTERNATOR ASSEMBLY	M12	9.0

 - 1092G10  single engine belt r r .  - 7055B64  Engine compartment DUST shield in front wheel arch (one), left or right - R.R. .  - 4450B10  Front WHEEL (one) - R.R. . - 4450B80 cap of one wheel - r+r .  - 7055B54  under-engine guard - r r . Connect the negative (-) battery terminalRemove the car from the ramps.