4450C34 BEARING OF ONE FRONT WHEEL HUB, L/H OR R/H - REPLACE WITH PILLAR REMOVED - Alfa - 156 - eLearn

3238235 - 4450C34 bearing of one front wheel hub, l/h or r/h - replace with pillar removed

) 1. Remove the wheel hub (1a) complete with bearings (1b) and axial bearing track (1c) from the steering knuckle using the hydraulic press, the half plates (1d) and the tool (1e).

	Name	Country
1d	Plate	1.820.019.000

	Name	Country
1e	Tool for Extracting/Fitting	1.870.658.000

1. Remove the dust cover from the wheel hub.Remove the radial bearing track from the wheel hub, as necessary, using a suitable chisel. Wear protective goggles.2. Remove the radial bearing track (2a) using the extractor (2b), the clamps (2c) and a suitable reaction base (2d).

	Name	Country
2b	Extractor	1.840.005.200

	Name	Country
2c	Clamps	1.840.005.103

1. Position the steering knuckle in the vice fitted with protective jaws.2. Undo the bolts (2a) and remove the outer track (2b) for the axial and radial bearings.

Refitting ( Removing

) Fit the outer race for the axial and radial bearings and secure it using the bolts.

When fitting a new bearing with a multi-polar magnetic codifier, remove the (black) plastic protection just before fitting the bearing.

The bearing should be fitted with the multipolar magnetic codifier facing towards the A.B.S. sensor

Avoid any impacts to the multipolar magnetic codifier. Avoid any contact between the multipolar magnetic codifer and dirty surfaces. At the end of the fitting operation, check that the multipolar magnetic codifier is clean and, if necessary, clean it using a clean cloth.

Fit the radial bearing track using the hydraulic press, a suitable plate and a suitable fitting tool.Fit the dust cover on the wheel hub.Fit the wheel hub complete with bearings and axial bearing track using the hydraulic press, a suitable plate and a suitable fitting tool.