1008B10 POWER UNIT FRONT MOUNT (TIMING SIDE) FLEXIBLE BLOCK - REPLACE - Alfa - 156 - eLearn

3237449 - 1008B10 power unit front mount (timing side) flexible block - replace

) Position the vehicle on the ramp. Proceed with removal - 4450B04 right front wheel r r . Proceed with removal - 7055B54 under-engine guard - r r . 1. Remove the buttons (1a), undo the attachments (1b) and remove the front right wheelarch mudguard (1c).

1. Undo the nut (1a) and remove the brackets (1b) securing the power steering pipes.

Position a hydraulic jack under the engine.1. Undo the bolts (1a) and (1b) and remove the flexible mounting for the power unit front support (1c).

Refitting ( Removing

) 1. Place the flexible mounting for the power unit front support (1a) back in its housing and secure it to the bodyshell by tightening the bolts (1b) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1b	Bolt	FRONT RUBBER MOUNTS	M8	(Bodyshell side) 3.2 ÷ 3.9

2. Tighten the bolt securing timing side rigid engine support to the flexible mounting to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
2	Bolt	ENGINE MOUNT TIMING SIDE	M12	(Flexible mounting side) 7.9 ÷ 9.7

Remove the hydraulic jack from under the engine.Fit the brackets securing the power steering pipes in their seatings and secure them with their nuts.Place the right front wheel housing dust protection back in its housing and secure it using the fastenings and buttons. Proceed with refitting - 7055B54 under-engine guard - r r . Proceed with refitting - 4450B04 right front wheel r r . Remove the car from the ramps.