3237717 - 1092E16 counter-rotating shaft drive toothed belt tensioner - r + r
Removing
(
Refitting
)
Place the car on the lifting bridge. - 7055B54 under-engine guard - r r- 4450B80 cap of one wheel - r+r - 4450B10 Front WHEEL (one) - R.R. - 7055B64 Engine compartment DUST shield in front wheel arch
(one), left or right - R.R. - 1092G10 single engine belt r r - 1092G20 engine component single belt fixed tensioner - one
- r + r - 1092A10 Crankshaft services PULLEY - R.R. - 1032D12 timing system protective cover(s) - r + r - 1092E10 counter-rotating shaft drive toothed belt - r + r1. Unscrew fixing screws (1a) of counter-rotating shaft toothed
belt drive pulley (1b) and remove it.
Refitting
(
Removing
)
Fit counter-rotating shaft toothed belt
drive pulley tensioner and fix it with its screws. - 1092E10 counter-rotating shaft drive toothed belt - r + r - 1032D12 timing system protective cover(s) - r + r - 1092A10 Crankshaft services PULLEY - R.R. - 1092G20 engine component single belt fixed tensioner - one
- r + r - 1092G10 single engine belt r r - 7055B64 Engine compartment DUST shield in front wheel arch
(one), left or right - R.R. - 4450B10 Front WHEEL (one) - R.R.- 4450B80 cap of one wheel - r+r - 7055B54 under-engine guard - r r
Removing
(
Refitting
)
Position the vehicle on the ramp.Ensure that the ignition key is in OFF
position, then disconnect the negative battery terminal. | Name | Connector |
|---|---|---|
| - | Battery | A1B |
Refitting
(
Removing
)
Place the counter-balance shaft belt tensioner
back in its housing and secure it without tightening the nut.
Proceed with refitting
- 1092E10 counter-rotating shaft
drive toothed belt - r + r
.
Proceed with refitting
- 1016A40 ignition coil cover on
cylinder head- r+r
.
Proceed with refitting
- 7055B54 under-engine guard -
r r
.
Proceed with refitting
- 4450B04 right front wheel r
r
.
Connect the negative (-) battery terminal.Remove the vehicle from the lift.