1092E22 COUNTER-ROTATING SHAFT DRIVE TOOTHED BELT DRIVE PULLEY - R + R - Alfa - 156 - eLearn

3237719 - 1092E22 counter-rotating shaft drive toothed belt drive pulley - r + r

) Place the car on the lifting bridge. - 7055B54 under-engine guard - r r- 4450B80 cap of one wheel - r+r - 4450B10 Front WHEEL (one) - R.R. - 7055B64 Engine compartment DUST shield in front wheel arch (one), left or right - R.R. - 1092G10 single engine belt r r - 1092G20 engine component single belt fixed tensioner - one - r + r - 1092A10 Crankshaft services PULLEY - R.R. - 1032D12 timing system protective cover(s) - r + r - 1092E10 counter-rotating shaft drive toothed belt - r + r1. Unscrew screws (1a) of counter-rotating shaft toothed belt drive pulley (1b) and remove it.

Refitting ( Removing

) Fit counter-rotating shaft toothed belt drive pulley and fix it with its screws.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	COUNTER-ROTATING SHAFT DRIVE PULLEY	M6	2.5

End by carrying out the following operations: - 1092E10 counter-rotating shaft drive toothed belt - r + r - 1032D12 timing system protective cover(s) - r + r - 1092A10 Crankshaft services PULLEY - R.R. - 1092G20 engine component single belt fixed tensioner - one - r + r - 1092G10 single engine belt r r - 7055B64 Engine compartment DUST shield in front wheel arch (one), left or right - R.R. - 4450B10 Front WHEEL (one) - R.R.- 4450B80 cap of one wheel - r+r - 7055B54 under-engine guard - r r

Removing ( Refitting

) Position the vehicle on the ramp.Ensure that the ignition key is in OFF position, then disconnect the negative battery terminal.

	Name	Connector
-	Battery	A1B

Proceed with removal - 4450B04 right front wheel r r . Proceed with removal - 7055B54 under-engine guard - r r . Proceed with removal - 1016A40 ignition coil cover on cylinder head- r+r . Proceed with removal - 1092E10 counter-rotating shaft drive toothed belt - r + r . 1. Undo the bolts (1a) and remove the counter-balance shaft drive belt drive pulley (1b).

Refitting ( Removing

) Place the counter-balance shaft drive belt drive pulley back in its housing and secure it tightening the bolts to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	COUNTER-ROTATING SHAFT DRIVE PULLEY	M6	(Timing drive pulley side.) 0.8÷1.0

Proceed with refitting - 1092E10 counter-rotating shaft drive toothed belt - r + r . Proceed with refitting - 1016A40 ignition coil cover on cylinder head- r+r . Proceed with refitting - 7055B54 under-engine guard - r r . Proceed with refitting - 4450B04 right front wheel r r . Connect the negative (-) battery terminal.Remove the vehicle from the lift.