3237935 - 2125C70 gearbox/brake lever mount - r r
Position the vehicle on the ramp. - 5530B10 battery - r+r . - 5530B52 Battery DRIP TRAY/SUPPORT - R.R. . 1. Disconnect the gear selector/engagement cables.2. Undo the nuts (2a) and release the bracket (2b) complete with gear selector/engagement cables.
1. Remove the gear lever boot.2. Remove the handbrake boot.3. Lift up the handbrake lever (3a) and loosen the nut (3b) tensioning
the handbrake cables.
Proceed with removal
- 1076B50 exhaust pipe attachment
to engine - r + r
.
Proceed with removal
- 1076B18 rigid section of exhaust
pipe between catalytic converter and silencer - r + r
.
1. Disconnect the intermediate exhaust silencer (1b) from the flexible
support (1a).
1. Remove the retainer (1a) and disconnect the handbrake cables
(1b).
1. Position a hydraulic jack under the gear lever and handbrake
lever support.2. Undo the bolts (2a) and the nuts (2b) fixing the gear lever and
handbrake lever support to the bodyshell.3. Lower the hydraulic jack as far as necessary and unscew nut (3a)
of gear selection/engagement cable support plate (3b).
1. Competely lower the hydraulic jack and remove the support for
the gear lever and handbrake lever.
1. Remove the safety plates (1a) and remove the gear selector/engagement
cable mounting brackets (1b).
1. Undo the nuts (1a) and remove the gear lever support (1b), complete
with gear selector/engagement cables (1c).
1. Remove the safety plates (1a) and the circlip (1b), then disconnect
and remove the gear selector/engagement cables (1c).
Refitting
(
Removing
)
Connect the gear selector/engagement cables
and fix them using the circlip and the safety plates.Fit the gear lever support, complete with
gear selector/engagment cables and fix them using the nuts.Fit the gear selector/engagement mounting
brackets and fix them using the nuts.Fit the gear selector/engagement mounting
brackets and fix them using the safety plates.Fit the gear lever and handbrake lever
support assembly using the hydraulic jack.Refit the gear selector/engagement cables
mount plate and secure it the appropriate nut.Tighten the bolts and nuts securing the
gearlever and handbrake lever mount to the body.Remove the hydraulic jack from underneath
the gear lever and handbrake lever support.Connect the handbrake cables and secure
them using the retainer.
Connect the intermediate exhaust silencer
to the flexible mount.
Proceed with refitting
- 1076B30 front exhaust silencer
- r + r
.
Proceed with refitting
- 1076B18 rigid section of exhaust
pipe between catalytic converter and silencer - r + r
.
- 3380A04 handbrake - check travel
.
Refit the handbrake boot.Fit the gear lever boot.Refit the bracket complete with gear engagement/selection
cables and secure it. - 5530B52 Battery DRIP TRAY/SUPPORT - R.R.
.
- 5530B10 battery - r+r
.
Remove the car from the ramps.