3310B36 REAR BRAKE CALLIPER - R R - Alfa - 156 - eLearn

3238045 - 3310B36 rear brake calliper - r r

) Position the vehicle on the ramp.Remove the handbrake boot.1. Lift up the handbrake lever (1a) and loosen the nut (1b) tensioning the handbrake cables.

- 4450B11 WHEEL (one) rear - R.R.1. Disconnect the handbrake cable from the rear brake caliper.

1. Undo the hose intermediate connector. 2. Remove the clip (2a) and disconnect hose (2b) from the mounting bracket.

1. Undo the bolts (1a) and remove the rear brake caliper (1b) complete with hose 1c).2. Remove the brake pads.

Refitting ( Removing

)

If one of the rear brake calipers is removed, it must be filled as follows:- slacken the bleed screw;- insert the end of a transparent tube in the hole on the bleed screw;- using an ordinary container with the recommended brake fluid, insert brake fluid into the caliper until air bubbles emerge from the threaded hole where the hose is connected; - tighten the bleed screw.

1. - Compress the rear brake caliper piston (1a) using the tool (1b) to facilitate the refitting of the brake caliper.

	Name	Country
1b	Key	1.822.108.000

Fit the rear brake caliper complete with pads and flexible pipe and secure by tightening the bolts to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR BRAKE CALIPER	M10	4.8 - 5.2

Connect the hose to the mounting bracket and secure it using the clip.Tighten the intermediate hose connector to torque.

	Fastening	Component	Ø	Value(daNm)
-	Connector	HOSE TO REAR BRAKE CALIPER	M10	1.3 - 1.5

Connect the handbrake cable to the rear brake caliper. - 4450B11 WHEEL (one) rear - R.R. - 3380A04 handbrake - check travel - 3330A14 HYDRAULIC BRAKING SYSTEM - Bleed air - 3330A10 BRAKE FLUID - Check level and top up, if necessary.Remove the car from the ramp.