3238764 - 7030B45 cable - r r

Removing ( Refitting ) Place manually using the pinion engine pin, the trasparent in the open position1. Loosen the screws2. Remove the trasparent3. Loosen the fixing screws (3a) and clear the engine (3b) from the entrainment hoses 4. Disconnect the pins (4a) of the drainage central (4b).5. Remove the race from the guides6. Loosen the posterior screw7. Remove the seal between the water unloading terminal and the guide8. Remove the water unloading terminal 9. Move back the slide so to release the entrainment hose Remove the entrainment hose Refitting ( Removing ) Verify that the entrainment hose has no sign of damage or wear.Install the entrainment hose in the sliding side theAnchor the entrainment hose to the slideInstall the water unloading terminal Apply the polyurethan seal than level it in order to allow the water passageTighten the posterior fixing screwInsert the race in the guidesConnect the pins of the drainage race1. Working on both guides, place manually the slides (1a) to the anterior endrun (1b) (open position). 1. Before reassemble the engine connect it to the electric connection (1a) and let the cam (1b) turn until its "S" points corrisponds with the microswitch (1c). The rotation shoul take place in the clockwise direction passing through the "C" point. Assemble the engine and fix it with the screwsAssemble the transparent and fix it with the screwsPlace manually using the pinion engine pin, the trasparent in the close position