3239034 - 7210B35 R.R. REAR OUTER WHEEL ARCH
Removing ( Refitting ) - 7210E51 left rear wing . Check if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges).Straighten the body if necessary.
1. Use a circular saw to cut along the cutting lines shown in the
figure.2. Cross-sections of key areas as a guide to allow the operator
to adjust cutting position and depth in order to avoid damage to
the underlying panels.3. Use a chamfering machine to remove the weld spots.4. Drill out the weld spots shown in the figure.5. Use a chisel and mallet to remove the outer wheel arch.
Straighten the panel edges
using a hammer and profiled stake.Use a grinding wheel to remove the weld
spot residues.1. Apply the electric weld paint finish.
1. Cut the part at the bench. Take care to leave a sufficiently
wide section of steel to attach the new part to.Use a rotary brush to remove the corrosion-proof
treatment from around the inner and outer edges of the part.2. Drill out equidistant holes along the section shown in the figure.3. Apply electroweldable paint finish to the panel edges indicated.
Refitting
(
Removing
)
1. Position the part on the car and secure using self-locking clips.Check the part is properly aligned.2. Use a circular saw to cut both panel edges in order to obtain
a perfect join.Remove the part and trim off any excess
sheet steel.
1. Position the part on the car and secure using self-locking clips.2. Use a spot welder to weld the roof panel in the areas shown in
the figure.3. Use a MIG welder to seam weld the upper panel edge and the door
sill rail.4. Use a MIG welder to fill the holes on the part made previously.
Correct any deformations in
the panel using a profiled stake and mallet.1. Use a grinding wheel to level the weld and remove.
1. Apply rust-proofing to newly-welded areas.2. Seal the areas indicated in the figure.Apply paint.3. Apply wax oil protection through the hole indicated.
- 7210E51 left rear wing
.