4130B80 RETURN PIPE BETWEEN DUPLEX PIPE AND FLUID RESEVIOR R R - Alfa - 156 - eLearn

3238152 - 4130B80 return pipe between duplex pipe and fluid resevior r r

) Position the vehicle on the rampDrain the power steering fluid from the reservoir using a suitable syringe. Proceed with removal - 4450B10 Front WHEEL (one) - R.R. (Left side). Proceed with removal - 7055B64 Engine compartment DUST shield in front wheel arch (one), left or right - R.R. (Left side). Proceed with removal - 7055B54 under-engine guard - r r . Proceed with removal - 1048A34 sleeve(s) from flow meter to air supply capacity case - r + r . Proceed with removal - 5530B10 battery - r+r . Proceed with removal - 5530B52 Battery DRIP TRAY/SUPPORT - R.R. . 1. Loosen the collar and disconnect the rigid return pipe between heat exchanger and fluid reservoir, reservoir rubber hose side.

1. Open the band and release the power steering system pipes.

1. Release the power steering system pipes from the fastenings.

1. Loosen band (1a) and disconnect the rigid return pipe between heat exchanger and fluid reservoir (1b).

1. Position a hydraulic jack under the differential.2. Undo the bolt fixing the power unit gearbox side rigid support to the flexible mounting.

1. Lower the power unit, as necessary, using the hydraulic jack and remove the rigid return pipe between heat exchanger and fluid reservoir.

Refitting ( Removing

) Refit the rigid return pipe between heat exchanger and fluid reservoir.Place the power unit back in its housing using the hydraulic jack.1. Undo the bolt fixing the gearbox side rigid power unit support to the flexible block to the specified torque.

	Fastening	Component	Ø	Value(daNm)
1	Bolt	POWER UNIT GEAR BOX END RIGID MOUNT	M10	(Flexible mounting side) 4.3 ÷ 5.3

2. Remove the hydraulic jack from under the differential.

Connect the rigid return pipe between heat exchanger and fluid reservoir and tighten the band.Secure the power steering system pipes to the fastenings.Secure the power assisted steering system pipes using the band.Connect the rigid return pipe between heat exchanger and fluid reservoir, reservoir rubber hose side, and tighten the band. Proceed with removal - 5530B52 Battery DRIP TRAY/SUPPORT - R.R. . Proceed with removal - 5530B10 battery - r+r . Proceed with removal - 1048A34 sleeve(s) from flow meter to air supply capacity case - r + r . Proceed with removal - 7055B54 under-engine guard - r r . Proceed with removal - 7055B64 Engine compartment DUST shield in front wheel arch (one), left or right - R.R. (Left side). Proceed with removal - 4450B10 Front WHEEL (one) - R.R. (Left side). Fill the power steering circuit with the recommended fluid.

	Type	Component	Name	Qty.
-	Fluid	POWER ASSISTED STEERING CIRCUIT	TUTELA GI/A	-

Bleed the power steering system as described belowWith the front wheels raised off the ground, with the engine switched off turn the steering wheel to full lock, left and right, 4-5 times. Check and, if necessary, top up the fluid level in the reservoir. Remove the car from the ramps.Start the engine and carry out 4 - 5 full steering wheel turn cycles (right and left). Top up the fluid level in the reservoir.