7065A12 FRONT SEAT BELT (ONE), LH OR RH, WITH PRETENSIONER ON WHEEL - R R - Alfa - 156 - eLearn

3238970 - 7065A12 front seat belt (one), lh or rh, with pretensioner on wheel - r r

Before disjoin and release pretention rods again, strictly keep to the following preliminary operations:Place ignition key on "STOP" position and remove it.Disconnect and insulate battery cables.Wait 10 minues before acting.KEEP TO ALL THE PRESCRIBED SAFETY RULES (SEE 7065A Precautions).

) - 7040L44 rear compartment scuff strip - r r - 7040H36 central trim lower element - r r1. Remove screw cover badge from front seat.2. Unscrew screw.3. Remove safety belt edge from seat.

1. Disconnect electric connection.

	Name	Connector
1	Driver's seat belt pre-tensioner	Q20

	Name	Connector
1	Front passenger seat belt pre-tensioner	Q21

2. Remove spring (2a) and extract passing pin (2b).3. Remove badge and unscrew nut.4. Unscrew screw.5. Remove safety belt with pretension rod.

Place pretension rod back in its ad hoc box by putting it on a clear surface.

Refitting ( Removing

) 1. Position pretension rod again.

Handle pretension rod with the greatest care. Check battery is connected.

2. Tighten screw to the prescribed couple.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	FRONT SEAT BELT PRETENSIONER.	-	3.6 - 4.4

3. Position safety belt rebound (3a) and tighten nut (3b) to the prescribed couple.

	Fastening	Component	Ø	Value(daNm)
3b	Nut	FRONT SEAT BELT IDLER.	-	3.6 - 4.4

4. Put badge on.5. Insert passing pin and put spring on.6. Connect electric connection.7. Place safety belt edge on seat.8. Tighten screw to the prescribed couple.

	Fastening	Component	Ø	Value(daNm)
8	Bolt	FRONT SEAT BELT END'.	-	3.6 - 4.4

Put screw cover badge on.

- 7040H36 central trim lower element - r r- 7040L44 rear compartment scuff strip - r r Connect battery.Check system functionality by using Examiner or other diagnosis instruments.