3239033 - 7210B25 windscreen base trim
Removing ( Refitting ) Check if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges).Straighten the body if necessary.
1. Use a chamfering machine to crop weld spots.2. Drill out weld spots.3. Use an oxyacetylene torch and steel brush to unweld welds at
the corners.Use a scalpel and mallet to remove spots
ground previously.4. Remove the beam at the base of the back window.
Straighten the beam seat panel
edges at the base of the back window using a mallet and profiled
stake.Use a grinding wheel to remove the weld
spot residues.Use a rotary brush to clean the treated
areas.1. Apply the electric weld paint finish.
Use a rotary brush to remove
the corrosion-proof treatment from around the inner and outer edges
of the part.1. Apply the electric weld paint finish to edges in contact with
the car.
Refitting
(
Removing
)
1. Fit the part correctly using self-locking clips.2. Use a spot welder to weld the areas shown in the figure.3. Use an oxyacetylene torch to hard-solder the roof corners of
the back window base beam.
Correct any deformations in
the panel using a profiled stake and mallet.1. Use a grinding wheel to level weld residues and remove.
1. Apply rust-proofing to newly welded areas.2. Apply sealant to the areas indicated in the figure.Apply paint.3. Apply wax oil inside the back window base beam.