3239072 - 1016E38 single cylinder head or (one) l or r, removed - grinding

Clean the residues of the old gasket from the lower surface of the cylinder head.1. Check that the planarity of the lower cylinder head surface is within the recommended values.

	Measurement		Value
1	Flatness of bottom surface (mm)		0.1

1. If the planarity of the lower cylinder head surface is not within the recommended values, reface the lower cylinder head surface without exceeding the minimum permissible height.

	Measurement		Value
1	Minimum permissible height after refacing (mm)		134.85 ÷ 135.15