4130B20 POWER STEERING PUMP R R - Alfa - 156 - eLearn

3238134 - 4130B20 power steering pump r r

Proceed with removal - 1016A40 ignition coil cover on cylinder head- r+r . Proceed with removal - 1008C10 power unit upper reaction link r r . Proceed with removal - 4130B10 power steering fluid resevoir r r . Proceed with refitting - 4130B10 power steering fluid resevoir r r . Proceed with refitting - 1008C10 power unit upper reaction link r r . Proceed with refitting - 1016A40 ignition coil cover on cylinder head- r+r .

Removing ( Refitting

) - 1092G10 single engine belt r rDisconnect the negative battery lead.Use a syringe to empty the power steering reservoir then discharge into a container.1. Undo bolts (1a) securing the left cylinder head cover and move the oil dipstick (1b) and air conditioner system pipes (1c) to one side.

1. Undo retaining bolts (1a) and remove left cylinder head exhaust manifold heat shield (1b).

1. Remove the two power steering pump inlet/outlet connectors (1a); one is unscrewed from the top of the vehicle and the other from the bottom; undo the bolts (1b) securing the power steering pump to the crankcase.2. Disconnect the compressor electrical connector and remove it from the mounting bracket.

Refitting ( Removing

) Fit the power assisted steering pump and secure it to the crankcase mounting.Connect the compressor electrical connector and secure it to the mounting bracket.Connect the pipe from pump to power steering box, pump side, and tighten the connector to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Connector	PIPE BTWN PUMP + POWER STEERING BOX	M16	(Power assisted steering pump side) 3.6 ÷ 4.4

Connect the feed pipe from reservoir to power steering pump, pump side, and tighten its connector to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Connector	POWER STEERING PUMP SUPPLY PIPE	M18	(Power assisted steering pump side) 3.6 ÷ 4.4

Fit the cylinder head exhaust manifold heat shield.Fit the oil dipstick mounting and the air conditioning system pipe to the left cylinder head. - 1092G10 single engine belt r rReconnect the negative battery terminal.Top up the power assisted circuit with the recommended fluid.

	Type	Component	Name	Qty.
-	Fluid	POWER ASSISTED STEERING CIRCUIT	TUTELA GI/A	-

Bleed the power steering system as described belowWith the front wheels raised off the ground, with the engine switched off turn the steering wheel to full lock, left and right, 4-5 times. Check and, if necessary, top up the fluid level in the reservoir. Remove the car from the ramps.Start the engine and turn the steering wheel to full lock, left and right, 4 - 5 times.Top up the fluid level in the reservoir.