3238949 - 7055A38 l/h or r/h rail moulding (door sill) - r+r

Removing ( Refitting ) Position the vehicle on a four column type lift.Raise the vehicle.1. Undo the lower bolts fixing the trim. 1. Undo the lower bolt fixing the additional front wheel arch liner.2. Remove the additional wheel arch liner at the bottom.3. Undo the front nut fixing the trim. 1. Remove the trim, releasing the adhesive tape (1a), the bolt (1b), the centering pin (1c) and the retainers (1d). Refitting ( Removing ) Check that the moulding is undamaged.1. Degrease the area of the bodywork where the adhesive tape is stuck using heptane. 2. Place the head of the bolt in position.3. Detach a section of protective film at the two ends of the adhesive tape.4. Position the trim and fit the bolt (2) and the centering pin (4a) in the bodyshell.5. Centre the trim with the bodywork profile.6. Remove the protective film from the adhesive tape by pulling the two ends (3).7. Engage the retainers.8. Tighten the nut.9. Place the additional wheel arch liner back in position.10. Tighten the bolt. 1. Tighten the lower bolts fixing the trim. Lower the vehicle and remove it from the lift.