3237904 - 1820B51 rigid input pipe to vibration damper - r r for rhd versions

RemovingEnsure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	A1B

 - 5530B10  battery - r+r - 5530B52  Battery DRIP TRAY/SUPPORT - R.R. - 1048A28  vacuum air circuit resonator pipe - r+r - 1048A48  throttle heater sleeve - r rDrain the brake-clutch fluid from the reservoir using a suitable syringe.1. Undo fittings (1a) and (1b) and remove the rigid inlet pipe to the vibration damper (1c). Place the rigid inlet pipe to the vibration damper and tighten the fittings to torque.

	Fastening	Component	Ø	Value(daNm)
-	Connector	RIGID INLET PIPE TO VIBRATION DAMPER	M12 x 1	(Rigid pipe from master cylinder side) 1.8

	Fastening	Component	Ø	Value(daNm)
-	Connector	RIGID INLET PIPE TO VIBRATION DAMPER	M12 x 1	(Vibration damper side) 1.8

 - 1048A48  throttle heater sleeve - r r - 1048A28  vacuum air circuit resonator pipe - r+r - 5530B52  Battery DRIP TRAY/SUPPORT - R.R. - 5530B10  battery - r+r- 0010T64 brake and or clutch fluid check level and top up as necessary  - 0010T65  hydraulic brake system bleed air - 0010T67  hydraulic clutch system bleed airConnect the battery/timing unit terminal (-)