3238070 - 3330C39 FLEXIBLE PIPE - REAR section - from brake fluid RESERVOIR to (pump) - MASTER CYLINDER R.R. on right hand drive versions

Removing ( Refitting ) Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

NameConnector
-Battery  A1B 
 - 1008C10  power unit upper reaction link r r1. Open the electrical connections box cover.2. Disconnect the engine coupling.3. Disconnect the electrical connections (3a) and (3b) for the rear Lambda sensors and the catalytic converter.

NameConnector
3aLambda sensor on catalyzer  K17 

NameConnector
3bLambda sensor on catalyzer -2  K18 
4. Disconnect the electrical connection for the detonation sensor, timing side.

NameConnector
4Detonation sensor - 1  K50 
1. Undo the bolts (1a) and remove the connections box (1b).
Drain the brake-clutch fluid from the reservoir using a suitable syringe.1. Disconnect the electrical connection from the injection-ignition electronic control unit.

NameConnector
1Engine management ECU  M10A 
1. Disconnect the fuel vapour pipe quick-release connector (1a), then release from retaining collars (1b).2. Undo the bolts (2a) and remove the bracket (2b) from the engine compartment bulkhead.
1. Undo the bolts (1a) and move power assisted steering fluid reservoir (1b) away from the engine bulkhead.
Disconnect the vacuum intake pipe from the brake servo.1. Undo the nuts (1a) and raise the brake-clutch fluid reservoir (1b) as much as necessary.2. Disconnect the flexible pipe - rear section - from the brake fluid reservoir to the master cylinder, reservoir side.
1. Release the flexible pipe - rear section - from the brake fluid reservoir to the master cylinder from the attachments on the engine bay bulkhead.2. Disconnect the flexible pipe - front section - from the brake fluid reservoir to the master cylinder, master cylinder side to make it easier to discnnect the rear attachment.3. Disconnect the flexible pipe - rear section - from the brake fluid reservoir to the master cylinder, master cylinder side, and remove it.
Refitting ( Removing ) Refit in its seating the flexible pipe - rear section - from the brake fluid reservoir to the master cylinder and connect it to the master cylinder.Connect the flexible pipe - front section - from the brake fluid reservoir to the master cylinder, master cylinder side.Secure the flexible pipe - rear section from the brake fluid reservoir to the master cylinder to the attachments on the engine bay bulkhead.Connect the flexible pipe - rear section - from the brake fluid reservoir to the master cylinder, reservoir side.Place the brake-clutch fluid reservoir back in its housing and secure it using the bolts.Connect the vacuum intake pipe to the brake servo.Secure the power steering reservoir to the engine bay bulkhead.Bolt the engine bay bulkhead bracket in place.Connec the fuel vapour pipe quick-release fitting, then secure to the support bracket on the engine bay bulkhead.Connect the electrical connections to the injection/ignition control unit.

NameConnector
-Engine management ECU  M10A 
Position the connector box and secure with bolts.Connect the electrical connection for the detonation sensor, timing side.

NameConnector
-Detonation sensor - 1  K50 
Connect the electrical connections for the rear Lambda sensors to the catalytic converter.

NameConnector
-Lambda sensor on catalyzer  K17 

NameConnector
-Lambda sensor on catalyzer -2  K18 
Connect the engine junction.Close the connection box cover. - 1008C10  power unit upper reaction link r r- 0010T64 brake and or clutch fluid check level and top up as necessary  - 0010T65  hydraulic brake system bleed air - 0010T67  hydraulic clutch system bleed airConnect the negative (-) battery terminal.