1080E41 TANK - SEPARATOR LINE - R R - Alfa - 156 - eLearn

3237599 - 1080E41 tank - separator line - r r

) Position the vehicle on the ramp. Proceed with the removal - 4450B11 WHEEL (one) rear - R.R. (Right side). 1. Undo the nuts (1a) and remove the protection (1b).

1. Position a hydraulic jack under the rear suspension crossmember.2. Undo the bolts (2a) and lower the rear suspension crossmember (2b), as necessary, using the hydraulic jack.

1. Position the hydraulic jack under the fuel tank.2. Undo the bolts fixing the fuel tank to the bodyshell.3. Release the handbrake cables from the fastenings on the fuel tank.

1. Undo the heat shield fixing bolts near the fuel tank.

Lower the fuel tank, as necessary, using the hydraulic jack.1. Disconnect the rapid attachment for the fuel vapour pipe between the tank and the separator, separator side.

Remove the float valve from the fuel tank, complete with fuel vapour pipe between the tank and the separator.At the bench, separator the fuel vapour pipe between the tank and the separator from the float valve.

Refitting ( Removing

) Connect the fuel vapour pipe between the tank and the separator to the float valve.Place the float valve, complete with fuel vapour pipe between the tank and the separator, back in its housing in the fuel tank.Connect the rapid attachment for the fuel vapour pipe from the tank to the separator, separator side.Place the fuel tank back in its housing using the hydraulic jack.Tighten the bolts fixing the heat shield near the fuel tank.Secure the handbrake cables to the fastenings on the fuel tank.Tighten the bolts fixing the fuel tank to the bodyshell.Remove the hydraulic jack from under the fuel tank.1. Place the rear suspension crossmember (1a) in its housing using the hydraulic jack (1b) and secure it tightening the bolts (1c) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1c	Bolt	REAR CROSS-BEAM	M10	(Bodyshell side) 6.2 ÷ 6.8

Remove the hydraulic jack from under the rear suspension crossmember.

Place the fuel filler pipe protection back in its housing and fasten it using the nuts. Proceed with the refitting - 4450B11 WHEEL (one) rear - R.R. (Right side). Remove the car from the ramp.