3330E10 FLEXIBLE PIPE (ONE), LEFT OR RIGHT, TO FRONT BRAKE CALIPERS - R.R . - Alfa - 156 - eLearn

3238083 - 3330E10 FLEXIBLE PIPE (one), left or right, to front brake calipers - R.R .

) Position the vehicle on the ramp. - 4450B10 Front WHEEL (one) - R.R.1. Remove the retaining plate.2. Undo the connectors and remove the flexible pipe to the front brake calipers after releasing it from the mounting bracket.

Refitting ( Removing

) Fit the flexible pipe to the front brake calipers, fixing it to the mounting bracket and tightening the connectors to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Connector	HOSE TO FRONT BRAKE CALIPER	M10	1.3 - 1.5

Fit the retaining plate. - 3330A14 HYDRAULIC BRAKING SYSTEM - Bleed air - 4450B10 Front WHEEL (one) - R.R.Remove the car from the ramps.

Removing ( Refitting

) Position the vehicle on the ramp. Proceed with removal - 4450B02 left front wheel r r . Remove the protective cap on the brake caliper bleed valve.Connect the collection system (pipe and reservoir) to the bleed valve on the brake caliper.Operate the brake pedal until the brake-clutch fluid reservoir and pipes are empty.1. Undo the connectors (1a) and remove the rigid pipe to the brake caliper (1b).2. Remove the stop (2a) and release the hose to the front brake caliper (2b) from the bottom bracket.Release the retaining clip on the front brake caliper hose from the central mounting bracket.3. Undo the connector on the front brake caliper flexible pipe, rigid pipe side.4. Remove the fastener and release the front brake caliper hose from the top mounting bracket, then remove it.

Refitting ( Removing

) 1. Refit the front brake caliper hose in its seating, then secure it to the top mounting bracket with the fastener.2. Tighten the connector on the front brake caliper flexible pipe, rigid pipe side.

	Fastening	Component	Ø	Value(daNm)
2	Connector	HOSE TO FRONT BRAKE CALIPER	M10	(Rigid pipe side) 1.4 ÷ 1.8

Engage the front brake caliper hose retaining clip to the central mounting bracket.3. Secure the front brake caliper hose to the bottom mounting with the fastening.4. Refit the rigid pipe to the brake caliper (4a) in its seating and tighten the connectors (4b) to the specified torque.

	Fastening	Component	Ø	Value(daNm)
4b	Connector	FRONT BRAKE CALIPER RIGID INLET PIPE	M10	(Brake caliper side) 1.4 ÷1.8

	Fastening	Component	Ø	Value(daNm)
4b	Connector	FRONT BRAKE CALIPER RIGID INLET PIPE	M10	(Flexible pipe side) 1.4 ÷ 1.8

Top up the brake-clutch fluid level - 0010T64 brake and or clutch fluid check level and top up as necessary . Bleed the air from the hydraulic braking system - 0010T65 hydraulic brake system bleed air . Proceed with refitting - 4450B02 left front wheel r r . Remove the car from the ramps.