7025B10 BOOT LID - SQUARE - Alfa - 156 - eLearn

3238732 - 7025B10 boot lid - square

Lift the boot lid.1. Loosen hinge bolts (1a) and adjust the boot lid position. Arrows (1b) indicate possible movements.Tighten the bolt to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	BOOT LID	-	1.1 - 1.3

2. Adjust buffer blocks if necessary.3. If necessary, adjust the position of the lock striker. Refer to op.. 7025B58 boot lid lock striker - r+r

If the adjustments described previously are insufficient, adjust the position of the boot lid hinges as described below.1. Remove the sealant, loosen the hinge bolts (1a) and adjust the position of the bonnet lid. Arrows (1b) indicate possible movements.Check that the boot lid is aligned.Tighten the bolt to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	BOOT LID HINGES	-	1.1 - 1.3

Test the boot lid works properly and is correctly aligned. Replace the sealant between hinges and body.If necessary, touch up the paintwork in the hinge area.